Open topic with navigation

Quick start

• The Scribe Adapter for Saleslogix overview provides a more detailed introduction to the adapter.
• See What's new for a brief look at what's changed since the last release.
• Requirements lists what you need to get started.
• If you are not already familiar with the adapter, spend a few minutes reading the Getting acquainted section.
• For information about installing Scribe Adapters, see the TIBCO Scribe® Insight Installation Guide.
• If this version of the Scribe Adapter for Saleslogix is released with Scribe Insight, install the Adapter from the Scribe Insight installer.
• If this version of the Scribe Adapter for Saleslogix is released outside of a Scribe Insight release, install the Adapter from the Scribe Product Download page.

To get started with the Adapter for Saleslogix

1. Install any requirements that are not already installed
2. Install the adapter
3. Test the installation
4. Begin building your DTS files. These are the specifications that are used when moving data from a source database to a target database. Refer to the lists of objects and custom functions for additional information when building your DTS files.

Note: TIBCOstrongly recommends you check the TIBCO™ eDelivery site for the latest release of any product before you install it. Always review the Release Notes on the TIBCO Scribe® Insight Help Release Notes page for important information.

See also

Getting started

TIBCO Scribe® Insight Help Library